Now you can remove the top screen housing entirely. You can then either wrap this connection in electrical tape, or just put a dab of hot glue on it to insulate it. If you have 30 gauge kynar wire you can just use that, if not, remove the longer black and red wires connecting these two boards and solder them to the speaker as seen below. Remove the screws holding the two small boards in. Once these are all removed you can remove the shoulder buttons and lift the motherboard from the shell.Īfter the screws are removed pry the back of the screen off to reveal the inside. Do it slowly and softly, it is fragile (if you break it you can fix it with somewhat of a workaround). These two ribbon cables are removed by pulling the brown locking mechanism forward. Do not remove the motherboard yet, first lift up the bottom screen large ribbon cable to reveal two smaller cables below it. Once removed disconnect the Wifi antenna cable, and the ribbon cables marked in red. Once opened, remove the screws marked in red. Using the tri-wing screwdriver, removed the screws from the points marked in red below.Īfter the screws are removed simply lift the rear of the shell to reveal the innards of the DS. 3 Surface Mount Resistor (or standard 330OHM resistor though this tutorial focuses on using a SMT resistor).I’m cross posting this tutorial here for anyone who isn’t following ! But if you want to use the left as well, solder it to the point referenced. This tutorial will only include the right speaker. Next, flip the motherboard over and solder the speakers to the points marked below. Once it’s screwed in you can glue the speaker down. You will need to remove it to screw the motherboard into your case after you finish your mod. Just let the speaker magnetize to the motherboard for now. Run the speaker wire under the DS slot like so. Return to the motherboard and flip it over. Next cut two strands of kynar wire (maybe four inches in length, you can always trim it later) and solder it to the connectors on the speaker. Then desolder one or both sets of speakers marked below. Once it’s out, push the screen out from the front of the case (just push against the plastic), and it will come out, speakers and all. You can either cut it, or roll it up and slip it through the metal ring. You’ll need to remove the ribbon cable holding the screen in. Once it’s open you should see something like this. I usually start at the hinge since that’s easy to separate. Just do the same as you did on the case and slowly work around. Now you need to flip it over, and pry the back off. Get the top screen and remove the covers marked in red. You can test it if you’d like, but it should work now. There is some double sided tape holding the right side of the bios module down, so it will be slightly tough to remove
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |